I already have IP cameras installed at various locations in my home. One of them is pointed at the front gate, which allows me to see whether if the gate is open or close. This is useful for times when I'm driving halfway, and then having the thought of wondering whether I have closed the gate or not.
But seeing the gate open 40km away is no help as well. So I decided to blow off the dust from my knock-off Arduino Duemilanove and put it to some good use.
My gate is controlled via a 315MHz (I think) RF keychain remote control. I know there are options where I could just buy a multifunctional RF Transmitter, but I wanted to go on the cheap, and also, I needed to solve this problem fast. These remotes are relatively cheap, and I keep a spare just in case I lose the one I normally carry. You can get these remotes clone for about RM50 - RM100, depending on the style and quality of the remote.
My remote runs on 12v battery. Getting this to work with the Arduino (as I have learned painfully) requires the use of other components (as Arduino tends to run 5V). Also, the button on the remote as I've found out is a pull-up, meaning, the voltage across the button is constantly on 12V, and when you depress the button, it goes to 0V and that's when the RF signal is sent out. I've tried using the digitalWrite and analogWrite function to see if I can short the button via 2 pins on the Arduino, but to no avail.
 |
| After figuring which of the 4 pins of the button is required, I soldered the 2 wires from the 2 pins. In case you don't know, this is the bottom side of the remote. The button is on the other side. |
Before I move on, I must give the disclaimer that I have pretty much zero background in electronics. What I mean is that while I'm interested in electronics, my theory of how transistors works is pretty much useless.
Here's the remote (the case removed) sitting on an Arduino breadboard shield. This makes it easier to wire everything up.
OK, moving on. The 2N2222 923 has 3 legs. The middle one is known as the base, and that's the one you will want to connect to the arduino digital pin (i used pin 2 for this). The other 2 legs of the transistor is connected to 2 pins of the remote button. Polarity matters in this case. I can't tell for sure which goes to which, however, I noticed that if I have the polarity reversed, the pins will short and the my remote button (which has a led indicator) will light up. So all I need to do is reversed it. Then that leaves the ground cable which you will connect from the arduino ground pin (look for GND), and you need to connect that to pin 1 of the transistor (if the flat side of the transistor is facing you, then pin 1 is the one on the far left).
Here's the Arduino sketch which I use:
void setup()
{
digitalWrite(2, HIGH); // sets the LED on
delay(1000); // waits for a second
digitalWrite(2, LOW); // sets the LED off
delay(1000); // waits for a second
}
void loop()
{
}
I know this is extremely lazy, as I have to upload the sketch everytime I want to open or close the gate. But this is just a conceptual test. Eventually, I guess you could hook this up to a webservice and have the gate control via an Android or iOS app.
Lastly, if case you're wondering how I'm going to control this remotely, I have VNC installed on a desktop sitting in my home, and the Arduino, along with the hooked up remote control connected to it. All I need to do is just to remote home, and upload the sketch to open or close the gate.
Nifty eh? Given all this done in less than 2 hours.
